New build , New guy

[shooty]

I am new to this but am willing to try anything, After reading all the posts and looking at simple and complex plans i am going with this to start, Very simple and may or may not work , This just an old hot water tank,In very good condtiion. I plan on just adding 10 gallons of oil to it, heating it up to about 700 degrees and venting all vapors out the top, If i can get 5 or 6 gallons out of it i will just drain whats left and start again, Very simple , i will let you know the out come Or if you have any input just drop a line Thanks

[moparguy]

Always remember, safety first. Also what are you planning to use for fuel, if natural gas or propane please post your fuelcost per gallon of finished product.

Good Luck

[deejaaa]

I am new to this but am willing to try anything, After reading all the posts and looking at simple and complex plans i am going with this to start, Very simple and may or may not work , This just an old hot water tank,In very good condtiion. I plan on just adding 10 gallons of oil to it, heating it up to about 700 degrees and venting all vapors out the top, If i can get 5 or 6 gallons out of it i will just drain whats left and start again, Very simple , i will let you know the out come Or if you have any input just drop a line Thanks
looks interesting. can you explain what each of the pictures are? is that pump using the green fuel going to be the heat source? are you going to add the oil through the same hole as the vent stack? this is my 1st post.